Tools Required for AssemblyAllen Wrench 5mm or 3/16", Allen Wrench 4mm or 5/32", Hammer, Phillips Screw DriverNote: A Magnetic or Powe
(2)FIG. #21. Begin Assembly by Flipping Base upright. Rotate top tube at approximately 90° from the modesty pane l as shown in Fig. #1. Begin assembly
FIG. #4FIG. #3FIG. #53. Place the Top (1) face down on a clean, flat surface. Attach Plastic Inserts (E7) by aligning the stubs with the pre-drilled
Adjustable Height Base OperationUnits with the adjustable height base adjust with the lever located just to the inside of each leg frame. Gently pushi
Comentarios a estos manuales